EPR 2025 EPR fees are in effect — start saving now
Honeywell

Honeywell PC43d Linerless Setup Guide

Setup instructions for Honeywell PC43 series compact desktop printers. Configure for efficient linerless label printing in retail and logistics.

20 minutes Medium Models: PC43d, PC43t, PC23d

Setup Steps

  1. 1

    Power off the printer

    Press and hold the power button until the printer shuts down. Wait for all indicator lights to turn off before proceeding.

  2. 2

    Open the media cover

    Grasp the cover release on the front of the printer and pull forward. The cover hinges open to expose the media compartment.

  3. 3

    Install linerless platen kit (if required)

    If your PC43d doesn't have the linerless option factory-installed, install the Honeywell linerless platen kit. This includes a silicone-coated roller and modified media guides.

    Warning: The linerless platen kit is essential. Using linerless media without it will cause adhesive buildup and damage the printer.

  4. 4

    Position the media roll

    Place the linerless roll on the media hanger with labels facing upward. Adjust the media guides to match your roll width.

    Tip: The print side (thermal coating) should face the print head when the media path is complete.

  5. 5

    Thread through the print mechanism

    Route the media under the print head assembly and over the linerless platen roller. Extend approximately 7cm beyond the front of the printer.

  6. 6

    Close the media cover

    Press down on the media cover until it clicks securely. The printer should automatically feed a short length of media.

  7. 7

    Configure via PrintSet

    Download Honeywell PrintSet from the Honeywell website. Connect to the printer and navigate to Media Settings. Select 'Linerless' as the media type.

  8. 8

    Set media parameters

    Configure media width, label length, and print speed. For linerless, set media tracking to 'Continuous' mode.

    Tip: Start with medium darkness (8-10) and adjust based on test prints.

  9. 9

    Calibrate media sensors

    Run the automatic calibration from PrintSet or use the printer's front panel: hold FEED + CANCEL during power-on.

  10. 10

    Test print

    Send a test label from PrintSet or your label design software. Verify print alignment, darkness, and cut position.

Troubleshooting

Media not feeding

Solution: Check that the linerless platen kit is correctly installed. Verify media guides aren't too tight. Run sensor calibration.

Sticky residue on rollers

Solution: Clean all rollers with Honeywell cleaning cards or isopropyl alcohol. Inspect the linerless platen roller for damage.

Print quality issues

Solution: Clean the print head with approved cleaning materials. Adjust print darkness. Check for worn or damaged head elements.

Cutter errors

Solution: Clear any paper fragments from the cutter mechanism. Run the cutter test from PrintSet. If problems persist, the cutter may need servicing.

Frequently Asked Questions

What's the difference between PC43d and PC43t?
The PC43d is a direct thermal printer (no ribbon required), while the PC43t supports both direct thermal and thermal transfer printing. For linerless labels, use the PC43d.
Can I retrofit an existing PC43d for linerless?
Yes, Honeywell offers a linerless retrofit kit that includes the silicone platen roller and necessary components. Installation requires some disassembly.
What media widths are supported?
The PC43d supports media from 25.4mm to 118mm wide. Common linerless widths include 58mm, 80mm, and 102mm for receipt and shipping applications.

More Guides

All printer guides General loading guide Hardware picker

Need Linerless Labels?

We stock rolls compatible with Honeywell printers. Request samples to test with your setup.

Request free samples