Epson

Epson TM-L90 Linerless Setup Guide

Setup instructions for Epson TM-L90 series liner-free label printers. Configure for optimal linerless label printing.

15 minutes Medium Models: TM-L90, TM-L90II, TM-L90 Liner-Free

Setup Steps

1

Power off and open cover

Turn off the printer using the power switch. Press the cover open lever to release and lift the paper cover.
2

Remove existing paper

If there's existing paper in the printer, remove it completely. Check for any paper fragments that might cause jams.
3

Position the linerless roll

Insert the linerless roll with the print side facing up. The paper should unroll from the top, towards the front of the printer.

Tip: Epson recommends using rolls with the Epson-certified linerless coating for best results.
4

Thread through the sensor

Guide the paper over the platen roller and through the paper guides. Ensure the paper is aligned with the left paper guide.
5

Close the cover

Press down on the paper cover until it clicks. The printer should automatically feed and cut the paper.
6

Configure via Epson utility

Use Epson's TMNet WebConfig or Windows configuration utility to set: paper width, liner-free mode enabled, and print density.
7

Calibrate paper sensors

Run automatic calibration from the configuration utility. This ensures accurate paper detection and cut positioning.
8

Print test label

Send a test print job to verify setup. Check for proper alignment, clear printing, and clean cuts.

Solution: Check paper path for obstructions. Ensure cover is fully closed. Power cycle the printer if error persists.

Solution: Recalibrate the paper sensor. Verify the correct paper type is selected in the configuration utility.

Solution: Check that the linerless roll hasn't been exposed to extreme temperatures or humidity. Try a fresh roll from sealed packaging.

What's the maximum print width for the TM-L90?

The TM-L90 supports print widths up to 72mm on 80mm paper, or 48mm on 58mm paper.

Does the TM-L90 require special linerless paper?

Yes, the TM-L90 is designed for use with liner-free label paper. Using standard thermal paper is not recommended in liner-free mode.

We stock rolls compatible with Epson printers. Request samples to test with your setup.